The following table shows the screw list and the image of the screws.
NOTE When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.
NOTE Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when replacing a component.
NOTE Screw color may vary with the configuration ordered.
NOTE As the VGA cables screw is installed or removed from the back of the computer, the VGA cables may use a hex nut.
Table 1. Screw listThe following table shows the screw list and the images for different components/locations.
Component
Screw type
Quantity
Image
Side cover
#6-32 (Captive screws)
1
System board
#6-32
M2x4
4
3
Hard drive support
#6-32
1
Fan and heat sink assembly
M3x25 (Captive screws)
3
WLAN card
M2x3.5
1
M.2 2230/2280 Solid-state drive
M2x3.5
3
Discrete graphics processing units (DGPU) bracket
M3x5
2
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\