Installing the network interface card
NOTE:The following procedure is for an optional component that is applicable for specific system configurations.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Steps
-
Place the network interface card on the card riser with it's connector facing the connector on the card riser.
-
Align the bracket on the network interface card to the bracket on the card riser.
-
Gently push the network interface card into the connector on the card riser to secure it.
-
Place the card riser on the system board.
-
Align the connector on the card riser to the connector slot on the system board.
-
Press downward on the "Push" tab on the card riser to connect it to the connector slot on the system board.
Data is not available for the Topic