Table 1. POST BehaviorThe following table describes the information about the computer’s post behavior:
Option
Description
Adapter Warnings
This option lets you choose whether the system displays warning messages when you use certain power adapters. This option is enabled by default.
Numlock LED
Allows you to enable or disable the Numlock feature when your computer starts. This option is enabled by default.
Keyboard Errors
Allows you to enable or disable the keyboard error reporting when the computer starts. The option
Enable Keyboard Error Detection is enabled by default.
Fast Boot
This option can speed up the boot process by bypassing some compatibility steps:
Minimal — The system boots quickly, unless the BIOS has been updated, memory changed, or the previous POST did not complete.
Thorough — The system does not skip any steps in the boot process.
Auto — This allows the operating system to control this setting (this works only when the operating system supports Simple Boot Flag).
This option is set to
Thorough by default.
Extend BIOS POST Time
This option creates an additional pre-boot delay.
0 seconds (default)
5 seconds
10 seconds
Full Screen Logo
This option will display full screen logo if your image match screen resolution. The option
Enable Full Screen Logo is not set by default.
Warnings and Errors
This option causes the boot process to only pause when warning or errors are detected. Choose any one of the option:
Prompt on Warnings and Errors - default
Continue on Warnings
Continue on Warnings and Errors
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\