Installing the heat sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.
![Image: Installing the heat-sink](https://dl.dell.com/content/guides/public/Html/optiplex7080_micro_sm/images/GUID-FDA4800E-A208-4A1F-9A32-AB1A98E73940-low.jpg)
Steps
- Align the screws of the heat sink with the holders on the system board and place the heat sink on the processor.
- Tighten the captive screws that secure the heat sink to the system board.
NOTE:Tighten the screws in a sequential order (1,2,3) as printed on the heat sink.
Data is not available for the Topic