- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Front bezel
- 2.5-inch hard-drive assembly
- Solid state drive
- WLAN card
- Fan assembly
- Heat sink
- Coin-cell battery
- Memory modules
- Speaker
- Graphics card
- Network interface card (NIC)
- Optional I/O modules (Type C/ HDMI/VGA/DP/Serial)
- Processor
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell Technologies
OptiPlex 7080 Micro Service Manual
Installing the front bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the front bezel and provides a visual representation of the installation procedure.
Steps
- Position the bezel to align the tabs with the slots on the chassis.
- Press the bezel until the release tabs click into place.
Next steps
- Install the side cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\