Installing the 2.5 in. hard-drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the hard-drive assembly and provides a visual representation of the installation procedure.
![Image: Installing the hard drive assembly](https://dl.dell.com/content/guides/public/Html/optiplex7080_micro_sm/images/GUID-FE1696A6-9535-4FDE-8E72-4BC785CFDE69-low.jpg)
Steps
- Insert the hard-drive assembly into the slot on the system.
- Slide the hard-drive assembly towards the connector in the system board until the release tabs clicks into place.
Data is not available for the Topic