Installing the power-supply unit (For systems with powered GPU)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
WARNING The cables and ports on the back of the power-supply unit are color-coded to indicate the different power wattage. Ensure that you plug in the cable to the correct port. Failure to do so may result in damaging the power-supply unit and/or system components.
About this task
The following images indicate the location of the power-supply unit and provides a visual representation of the installation procedure.
Steps
Slide the power-supply unit into the chassis until the securing tab snaps into position.
Replace the three screws (#6-32) that secure the power-supply unit to the chassis.
Route the power cable through the routing guides on the chassis and connect the power cables to their respective connectors on the system board.
Align the triangles on the powered GPU cable holder with the triangles on the chassis.
Place the powered GPU cable holder on the computer chassis until it clicks to place.
Route the power cable through the retention tab on the cable holder.
Connect the two power cables, through the slot on the cable holder, to the connector on the powered GPU.