If you are replacing a component, remove the existing component before performing the installation procedure.
WARNING The cables and ports on the back of the power-supply unit are color-coded to indicate the different power wattage. Ensure that you plug in the cable to the correct port. Failure to do so may result in damaging the power-supply unit and/or system components.
About this task
The following images indicate the location of the power-supply unit and provides a visual representation of the installation procedure.
Steps
Slide the power-supply unit into the chassis until the securing tab snaps into position.
Replace the three (#6-32) screws to secure the power-supply unit to the chassis.
Route the power cable through the routing guides on the chassis and connect the power cables to their respective connectors on the system board.