The figure indicates the location of the hard-drive assembly module and provides a visual representation of the removal procedure.
Steps
Remove the M2x3 screw that secures the hard-drive assembly to the cover.
Turn the hard-drive assembly.
Lift the cable release latch and disconnect the hard-drive cable from the connector on the system board.
Carefully unroute the hard-drive cable from the slot on the chassis.
NOTE:Observe the routing of the hard-drive cable inside the chassis as you remove them. Route the cable properly when you replace the component to prevent the cable from from being pinched or crimped.
Remove the hard-drive assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\