Table 1. POST BehaviorThe following table describes the information about
the computer’s post behavior:
Option
Description
Numlock LED
Allows you to enable or disable the Numlock feature
when your computer starts. This option is enabled by default.
Keyboard Errors
Allows you to enable or disable the keyboard error
reporting when the computer starts. The option Enable Keyboard
Error Detection is enabled by default.
Fast Boot
This option can speed up the boot process by bypassing
some compatibility steps:
Minimal
— The system boots quickly, unless the BIOS has been updated, memory
changed, or the previous POST did not complete.
Thorough
— The system does not skip any steps in the boot process.
Auto — This
allows the operating system to control this setting (this works only
when the operating system supports Simple Boot Flag).
This option is set to Thorough by default.
Extend BIOS POST Time
This option creates an additional pre-boot delay.
0 seconds (default)
5 seconds
10 seconds
Full Screen Logo
This option will display full screen logo if your
image match screen resolution. The option Enable Full Screen Logo is not set by default.
Warnings and Errors
This option causes the boot process to only pause
when warning or errors are detected. Choose any one of the option:
Prompt on Warnings
and Errors (default)
Continue on Warnings
Continue on Warnings
and Errors
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\