- Notes, cautions, and warnings
- Views of OptiPlex Tower Plus 7010
- Set up your computer
- Specifications of OptiPlex Tower Plus 7010
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Ethernet
- Wireless module
- Audio
- Storage
- Redundant Array of Independent Disks (RAID)
- Media-card reader
- Power ratings
- GPU—Integrated
- External display support (GPU—Integrated)
- GPU—Discrete
- External display support (GPU—Discrete)
- Hardware security
- Environmental
- Regulatory compliance
- Operating and storage environment
- Working inside your computer
- Removing and installing side cover
- Removing and installing coin-cell battery
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex Tower Plus 7010 Owner's Manual
Installing the primary 2.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 2.5-inch hard drive and provides a visual representation of the installation procedure.
Steps
- Insert the hard drive assembly into the slot on the computer until it clicks into place.
- Connect the data and power cables to the connectors on the hard drive.
Next steps
- Install the side cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\