- Notes, cautions, and warnings
- Views of OptiPlex Tower Plus 7010
- Set up your computer
- Specifications of OptiPlex Tower Plus 7010
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Ethernet
- Wireless module
- Audio
- Storage
- Redundant Array of Independent Disks (RAID)
- Media-card reader
- Power ratings
- GPU—Integrated
- External display support (GPU—Integrated)
- GPU—Discrete
- External display support (GPU—Discrete)
- Hardware security
- Environmental
- Regulatory compliance
- Operating and storage environment
- Working inside your computer
- Removing and installing side cover
- Removing and installing coin-cell battery
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex Tower Plus 7010 Owner's Manual
Installing optional SMA module
Prerequisites
About this task
The following images indicate the location of the optional SMA module and provide a visual representation of the installation procedure.
Steps
- To remove the PCIe dummy bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release it, and then lift the bracket out of the system.
- Lift the pull tab to open the PCIe door.
- Insert the optional SMA module into its slot on the system board.
- Route the SMA module cable through the cable holder on the chassis.
- Close the cable holder to secure the SMA module cable in place.
Next steps
- Install the wireless card.
- Install the side cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\