Installing the internal antenna kit
CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the internal antenna and provides a visual representation of the installation procedure.
Steps
- Peel away the protective tape from the back of the antennas.
- Insert the antennas into the slots on the chassis.
The antennas should be installed on the appropriate slots on the chassis.
Table 1. Antenna-cable color schemeThe following table provides the Antenna-cable color scheme
CHASSIS LABEL
| ANTENNA-CABLE COLOR
|
---|
ANT-W
| White
|
ANT-B
| Black
|
- Replace the two screws (M3x3) that secures the internal antennas to the chassis.
- Route the internal antenna cable through the routing guide on the chassis.
- Route the internal antenna cable through the hole on the chassis.
- Connect the antenna cables to the connectors on the wireless card.
- Align and place the wireless card bracket on the wireless card
- Replace the single screw (M2x3.5) that secures the internal antennas to the chassis.
Data is not available for the Topic