Installing the processor fan and heat-sink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: If either the processor or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure that thermal conductivity is achieved.
About this task
The following image indicates the location of the processor fan and heat-sink and provides a visual representation of the installation procedure.
Steps
Align the screws on the processor fan and heat-sink assembly with the screw holders on the system board and place the processor fan and heat-sink assembly on the processor.
NOTE:Ensure that the triangle mark is directed towards the rear side of the computer.
In the sequential order (1->2->3->4), tighten the captive screws to secure the processor fan and heat-sink assembly to the system board.
NOTE:Tighten the screws in a sequential order (1,2,3,4) as printed on the heat-sink assembly.
Connect the processor-fan cable to the connector on the system board.