Installing the powered GPU
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the powered graphical processing unit and provide a visual representation of the installation procedure.
![This image displays the installation of the powered GPU](https://dl.dell.com/content/guides/public/Html/opti7000mt_sm/images/GUID-A42281A0-7F77-4B0B-81EE-628A73190AA7-low.jpg)
![This image displays the installation of powered GPU cable holder](https://dl.dell.com/content/guides/public/Html/opti7000mt_sm/images/GUID-DA845FBA-8B17-4225-B48E-9AB30F566A06-low.jpg)
Steps
- Lift the pull tab to open the PCIe door.
- Align the powered GPU with the PCI-Express card connector on the system board.
- Using the alignment post, connect the powered GPU in the connector and press down firmly. Ensure that the powered GPU is firmly seated.
- Close the PCIe door.
- Align the triangles on the powered GPU cable holder with the triangles on the chassis.
- Place the powered GPU cable holder on the computer chassis until it clicks to place.
- Route the power cable through the retention tab on the cable holder.
- Connect the two power cables, through the slot on the cable holder, to the connector on the powered GPU.
Data is not available for the Topic