Installing system
fan
- Insert the grommets into the slots on the
back of the computer.
- Hold the system fan with the cable facing
the bottom of the computer.
- Align the grooves of the system fan with the grommets on the chassis
wall.
- Pass the grommets through the corresponding
grooves on the system fan [1].
- Stretch the grommets and slide the system
fan toward the computer until it locks into place [2].
NOTE Install the lower two grommets first.
- Connect the system fan cable to the connector
on the system board [3].
- Route the intrusion switch cable through the
fan grommet [2].
- Insert the intrusion switch cable into the system board [1].
- Close the front panel door.
- Install the:
- Front bezel
- Side cover
- Follow the procedure in After working inside
your computer.
Data is not available for the Topic