Installing system
fan
Steps
- Insert the grommets into the slots on the back of the computer.
- Hold the system fan with the cable facing the bottom of the computer.
- Align the grooves of the system fan with the grommets on the chassis
wall.
- Pass the grommets through the corresponding grooves on the system
fan.
- Stretch the grommets and slide the system fan toward the computer
until it locks into place.
NOTE:Install the lower two grommets first.
- Connect the system fan cable to the connector on the system board.
- Secure the intrusion
switch cable to the system fan with an adhesive tape.
- Route the intrusion
cable through the system fan grommet.
- Connect the intrusion switch cable to the connector on the system board.
- Close the front panel door.
- Install the:
-
bezel
- cover
- Follow the procedure in After working inside
your computer.
Data is not available for the Topic