Removing the display assembly
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- Unroute the display cable from the routing guides in the palmrest assembly.
- Peel the adhesive tape that secures the display cable in place.
- Open the latch and disconnect the display cable from the connector on the system board.
- Remove the
(M2.5x4) and six (M2.5x5) screws
that secure the display hinges to the system.
- Lift the left and right hinges in upward direction away from the palmrest assembly.
- Lift the palmrest assembly off the display assembly.
Data is not available for the Topic