Installing the I/O cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the I/O cable and provides a visual representation of the installation procedure.
![Image: Installing the battery](https://dl.dell.com/content/guides/public/Html/latitude-3530-service-manual/images/GUID-BA4DF514-24E5-4AA6-A407-3ED9DA2294CA-low.jpg)
Steps
- Route the I/O cable through the routing guides and adhere the adhesive tape to secure the I/O cable in place.
- Connect the I/O cable to the connector on the system board, adhere the adhesive tape, and close the latch.
- Connect the I/O cable to the connector on the I/O board, adhere the adhesive tape, and close the latch.
Data is not available for the Topic