Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the touchpad and provides a visual representation of the installation procedure.
![Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly](https://dl.dell.com/content/guides/public/Html/latitude-3530-service-manual/images/GUID-99216AF4-822D-4C1C-815B-409950EF8D35-low.jpg)
Steps
- Align and place the touchpad module into the slot on the palmrest assembly.
- Install the four (M2x2) screws to secure the touchpad module to the palmrest assembly.
- Align and place the touchpad bracket on the touchpad module.
- Install the three (M2x2.5) screws to secure the touchpad bracket to the touchpad module.
- Affix the adhesive tapes to secure the touchpad module in place.
- Connect the touchpad cable to the connector on the system board and close the latch.
Data is not available for the Topic