- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- MicroSD-card
- SIM card tray
- Base cover
- Battery cable
- Memory module
- M.2 solid state drive
- M.2 solid-state drive conversion bracket
- M.2 solid-state drive conversion plate
- Hard-disk drive assembly
- WLAN card
- Wireless Wide Area Network (WWAN) card
- System fan
- Battery
- I/O cable
- Display assembly
- Display bezel
- Display panel
- Heat sink
- Power adapter port
- Coin-cell battery
- USB cable
- Ethernet port
- I/O board
- Power button
- System board
- Speakers
- Touchpad
- WWAN I/O board
- Palmrest assembly
- Camera
- Display cable
- Display back-cover
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 3530 Service Manual
Installing the palmrest assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palmrest assembly.
NOTE:The green rubber bumpers are pre-attached to the palmrest assembly for non hard-disk drive with 3-cell battery configurations. Ensure to remove the green rubber bumper before installing a hard-disk drive or a 4-cell battery on to the palmrest assembly.
Steps
After performing the succeeding steps, you are left with the palmrest assembly.
Next steps
- Install the system board.
- Install the WWAN I/O board for systems enabled with 4G LTE.
- Install the USB cable.
- Install the coin-cell battery.
- Install the I/O board.
- Install the power adapter port.
- Install the heatsink assembly.
- Install the system fan.
- Install the display assembly.
- Install the I/O board cable.
- Install the WWAN card for systems enabled with 4G LTE.
- Install the WLAN card.
- Install the hard-disk drive.
- Install the M.2 SSD conversion plate.
- Install the M.2 SSD conversion bracket.
- Install the M.2 SSD.
- Install the memory module.
- Install the battery.
- Install the base cover.
- Install the SIM card tray for 4G LTE enabled systems.
- Install the microSD-card.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\