Installing the hard-disk drive bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the hard-disk drive bracket and provides a visual representation of the installation procedure.
![Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly](https://dl.dell.com/content/guides/public/Html/latitude-3530-service-manual/images/GUID-42CDFAAC-4F99-4F77-AAB7-E68D18422975-low.jpg)
Steps
- Lift the silver foil, align and place the hard-disk drive in the hard-disk drive bracket.
- Install the four (M3x3) screws to secure the hard-disk drive to the hard-disk drive bracket.
- Connect the hard-disk drive cable to the connector on the hard-disk drive bracket.
Data is not available for the Topic