If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the hard-disk drive assembly and provides a visual representation of the installation procedure.
NOTE:The following steps are applicable only for computers that are shipped with a 3-cell battery. You cannot install the 2.5-inch SATA hard-drive on computers with a 4-cell battery.
NOTE:Computers that are shipped with 3-cell battery contain a rubber bumper that must be removed manually before installing the hard-disk drive assembly.
Steps
Align and place the hard-disk drive assembly in the slot on the palmrest assembly.
Tighten the four (M2X4.5) screws to secure the hard-disk drive assembly to the palmrest assembly.
Connect the hard-disk drive cable to the connector on the system board.