Installing the ethernet port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the ethernet port and provides a visual representation of the installation procedure.
![Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly](https://dl.dell.com/content/guides/public/Html/latitude-3530-service-manual/images/GUID-C680DC71-999E-4302-976E-E270157AD2FA-low.jpg)
Steps
- Align and place the ethernet on the I/O board.
- Install the
two (M2x5) screws to secure the ethernet on the I/O board.
- Press the hinge in downward direction toward the palmrest assembly.
- Install the
four (M2.5x5) screws to secure the hinge bracket on the palmrest assembly.
Data is not available for the Topic