Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation procedure.
![Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly](https://dl.dell.com/content/guides/public/Html/latitude-3530-service-manual/images/GUID-83FA32DE-CFA7-4643-ADA9-7EAEB28BC59F-low.jpg)
![Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly](https://dl.dell.com/content/guides/public/Html/latitude-3530-service-manual/images/GUID-AB3A4BE2-20B6-4504-BDCC-8CCBAF884D8C-low.jpg)
Steps
- Align and place the system chassis under the hinges of the display assembly.
- Press the left and right hinges in downward direction toward the palmrest assembly.
- Install the
(M2.5x4) and six (M2.5x5) screws
to secure the display hinges to the palmrest assembly.
- Connect the display cable to the connector on the system board and close the latch.
- Route the display cable through the routing guides in the palmrest assembly.
- Affix the adhesive tape to secures the display cable in place.
Data is not available for the Topic