Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 3530 Service Manual

PDF

Removing the palmrest assembly

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the microSD-card.
  3. Remove the SIM card tray for 4G LTE enabled systems.
  4. Remove the base cover.
  5. Remove the battery.
  6. Remove the memory module.
  7. Remove the M.2 SSD.
  8. Remove the M.2 SSD conversion bracket.
  9. Remove the M.2 SSD conversion plate.
  10. Remove the hard-disk drive.
  11. Remove the WLAN card.
  12. Remove the WWAN card for systems enabled with 4G LTE.
  13. Remove the I/O board cable.
  14. Remove the display assembly.
  15. Remove the system fan.
  16. Remove the heatsink assembly.
  17. Remove the power adapter port.
  18. Remove the I/O board.
  19. Remove the coin-cell battery.
  20. Remove the USB cable.
  21. Remove the WWAN I/O board for systems enabled with 4G LTE.
  22. Remove the system board.
    NOTE:The system board can be removed along with the heat sink.

About this task

The following images indicate the location of the palmrest assembly.

Image: Removing the palmrest assembly

NOTE:The green rubber bumpers are pre-attached to the palmrest assembly for non hard-disk drive with 3-cell battery configurations. Ensure to remove the green rubber bumper before installing a hard-disk drive or a 4-cell battery on to the palmrest assembly.

Steps

After performing the preceding steps, you are left with the palmrest assembly.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\