NOTE:If the CMOS battery is disconnected from system board for service, there will be a delay during system boot as the system undergoes RTC battery reset.
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
Steps
Open the mylar sheet that covers the coin-cell battery cable.
Disconnect the coin-cell battery cable from the connector on the I/O board.
Lift and remove the coin-cell battery from the palmrest assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\