Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 3530 Service Manual

PDF

Installing the system board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE:The location of the memory module may vary depending on the configuration of your computer.

System board connectors

The following images indicate the location of the system board and provide a visual representation of the installation procedure.

Steps

  1. Align and place the system board into the slot on the palm-rest assembly.
  2. Install the two (M2x2) screws to secure the system board in place.
  3. Align and place the Type-C bracket on the system board.
  4. Install the two (M2x5) screws to secure the Type-C bracket in place.
  5. Connect the display cable and I/O cable to the connector on the system board, close the latches and affix the adhesive tapes.
  6. Connect the touchpad cable, keyboard cable, and USB cable to the connector on the system board and close the latches.
  7. Connect the speaker cable, power adapter port cable, hard-disk drive cable, and fan cable to the connector on the system board.
  8. For 4G LTE enabled computers, affix the WWAN I/O board cable on the palm-rest assembly.
  9. Press the hinge in a downward direction toward the palm-rest assembly.
  10. Install the (M2.5x6) and the (M2.5x4) screws to secure the hinge to the palm-rest assembly.

Next steps

  1. Install the heatsink assembly.
  2. Install the WLAN card.
  3. Install the hard-disk drive for computers shipped with hard-disk drive.
  4. Install the M.2 SSD.
  5. Install the memory module.
  6. Install the battery.
  7. Install the base cover.
  8. Install the SIM card tray for 4G LTE enabled computers.
  9. Install the microSD-card.
  10. Follow the procedure in after working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\