Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 3530 Service Manual

PDF

Installing the coin-cell battery

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE:If the CMOS battery is disconnected from system board for service, there will be a delay during system boot as the system undergoes RTC battery reset.

The following image indicates the location of the coin-cell battery and provides a visual representation of the installation procedure.

Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly

Steps

  1. Align and place the coin-cell battery on the palmrest assembly.
  2. Connect the coin-cell battery cable to the connector on the I/O board.
  3. Close the mylar sheet to cover the coin-cell battery cable.

Next steps

  1. Install the WWAN card for 4G LTE enabled systems.
  2. Install the base cover.
  3. Exit the service mode
  4. Install the SIM card tray for 4G LTE enabled systems.
  5. Install the microSD-card.
  6. Follow the procedure in after working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\