Disconnect the battery cable from the connector on the system board.
To remove the WWAN card:
Remove the M2.0 x 3.0 screw that secures the WWAN bracket to the WWAN card [1].
Lift the WWAN bracket that secures the WWAN card [2] .
Disconnect the WWAN cables from the connectors on the WWAN card [3] .
NOTE There is an adhesive pad on the routing pad of the system board which secure the wireless and WWAN cards. Removing the wireless or WWAN card requires a small amount of additional force to separate the card from the adhesive pads
Remove the WWAN card:
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\