Installing system board
-
Align the system board with the screw holders on the system.
-
Replace the M2.0 x 3.0 screws to secure the system board to the system.
-
Connect the speaker, LED board, coin cell battery, touchpad, and USH cables, and power connector, cables to the connectors on the system board.
-
Connect the eDP cable to the connector on the system board.
-
Place the metal bracket over the eDP cable and replace the M2.0 x 3.0 screws to secure it.
-
Place the metal bracket over the memory module connectors and replace the M2.0 x 3.0 screws to secure it to the system.
NOTE Replacement system boards do not include the SIM card tray (if available), USB Type-C bracket, and DDR ESD bracket and must be transferred.
-
Install the
heat sink.
-
Install the
WLAN card.
-
Install the
WWAN card.
-
Install the
PCIe SSD card.
-
Install the
memory module.
-
Connect the battery cable to the connector on the system board.
-
Install the
base cover.
-
Install the
dummy SIM card tray.
-
Install the
SIM card.
-
Follow the procedure in
After working inside your computer.
Data is not available for the Topic