NOTE To disconnect the speaker, LED board, coin cell battery, and the power connector port cables, use a plastic scribe to release the cables from the connectors. Do not pull the cable as it may result in breakage.
speaker cable [1]
LED board cable [2]
coin cell battery cable [3]
touchpad cable and USH board cable [4]
power connector port [5]
To remove the system board:
Remove the USB type-C bracket.
Image does not display the USB type-C bracket removal.
Remove the three (M2.0 x 5.0) screws that secure the system board [1].
Lift the system board away from the computer [2].
Remove the two (M2.0x5.0) screws that secure the USB Type-C bracket.
Flip the system board, peel off the tapes securing the bracket and remove the USB Type-C port from the system board.
NOTE When removing or reinstalling the USB Type-C bracket to the system board, technicians must place the system board on an ESD mat to avoid damage.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\