Removing the I/O board
About this task
NOTE: The following image is from systems without power-button board.
The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.
Steps
- For systems shipped with power button, peel the adhesive, open the latch and disconnect the power button cable from the connector on the I/O board.
- Open the latch and disconnect the I/O cable from the connector on the system board.
- Disconnect the USB cable and coin-cell cable from the connectors on the system board.
- Remove the two (M2x3) screws that secure the I/O board on the palmrest assembly.
- Lift and remove the I/O board from the palmrest assembly.
Data is not available for the Topic