- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- MicroSD-card
- SIM card tray
- Base cover
- Battery cable
- Memory module
- M.2 solid-state drive
- M.2 solid-state drive conversion bracket
- M.2 solid-state drive conversion plate
- Hard-disk drive assembly
- WLAN card
- WWAN card
- System fan
- Battery
- I/O cable
- Display assembly
- Display bezel
- Display panel
- Heatsink assembly
- Power adapter port
- Coin-cell battery
- USB cable
- Ethernet port
- I/O board
- Power button
- System board
- Speakers
- Touchpad
- WWAN I/O board
- Palmrest assembly
- Camera
- Display cable
- Display back-cover
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 3430 Service Manual
Installing the power button without fingerprint reader
About this task
The following image indicates the location of the power button without fingerprint reader and provides a visual representation of the removal procedure.
Steps
Align and place the power button into the slot on the palmrest assembly.
Next steps
- Install the ethernet port.
- Install the I/O board.
- Install the base cover.
- Exit the service mode
- Install the SIM card tray for 4G LTE enabled systems.
- Install the microSD-card.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\