Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure.
![Removing the heat sink](https://dl.dell.com/content/guides/public/Html/latitude-3430-service-manual/images/GUID-6403C72B-EC21-465A-A6B2-FC979002E5B7-low.jpg)
Steps
- Align the notch on the solid-state drive with the tab on the solid-state drive slot.
- Slide the solid-state drive into the solid-state drive slot on the system board.
- Replace the (M2x3) screw to secure the solid-state drive to the system board.
Data is not available for the Topic