Installing the ethernet port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the ethernet port and provides a visual representation of the installation procedure.
![Removing the heat sink](https://dl.dell.com/content/guides/public/Html/latitude-3430-service-manual/images/GUID-D15422A0-52F7-4846-9CF7-E8A5A4F6477A-low.jpg)
Steps
- Align and place the ethernet on the I/O board.
- Install the
(M2x5) screw to secure the ethernet on the I/O board.
- Press the hinge in downward direction toward the palmrest assembly.
- Install the
(M2.5x4) and two (M2.5x6) screws to secure the hinge bracket on the palmrest assembly.
Data is not available for the Topic