- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- MicroSD-card
- SIM card tray
- Base cover
- Battery cable
- Memory module
- M.2 solid-state drive
- M.2 solid-state drive conversion bracket
- M.2 solid-state drive conversion plate
- Hard-disk drive assembly
- WLAN card
- WWAN card
- System fan
- Battery
- I/O cable
- Display assembly
- Display bezel
- Display panel
- Heatsink assembly
- Power adapter port
- Coin-cell battery
- USB cable
- Ethernet port
- I/O board
- Power button
- System board
- Speakers
- Touchpad
- WWAN I/O board
- Palmrest assembly
- Camera
- Display cable
- Display back-cover
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 3430 Service Manual
Entering BIOS setup program
Steps
- Turn on your computer.
-
Press F2 immediately to enter the BIOS setup program.
NOTE: If you wait too long and the operating system logo appears, continue to wait until you see the desktop. Then, turn off your computer and try again.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\