The following image indicates the location of the hard-disk drive assembly and provides a visual representation of the removal procedure.
NOTE: The following steps are applicable only for computers that are shipped with a 3-cell battery. You cannot install the 2.5-inch SATA hard-drive on computers with a 4-cell battery.
Steps
Disconnect the hard-disk drive cable from the connector on the system board.
Loosen the four (M2X4.5) screws that secure the hard-disk drive assembly to the palmrest assembly.
Lift and remove the hard-disk drive assembly from the slot on the palmrest assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\