Removing the WWAN I/O board
About this task
The following image indicates the location of the WWAN I/O board and provides a visual representation of the removal procedure.
NOTE: The following steps are applicable only for 4G LTE enabled systems.
Steps
- Remove the two (M2x3) screws that secure the WWAN I/O board to the palmrest assembly.
- Gently flip the WWAN I/O board toward right.
- Open the latch and disconnect the WWAN cable from the connector on the WWAN I/O board.
- Lift and remove the WWAN I/O board from the palmrest assembly.
Data is not available for the Topic