Removing the I/O cable
About this task
The following image indicates the location of the I/O cable and provides a visual representation of the removal procedure.
Steps
- Peel the adhesive tape, open the latch and disconnect the I/O cable from the connector on the system board.
- Peel the adhesive tape and unroute the I/O cable from the routing guides in the palmrest assembly.
- Peel the adhesive tape, open the latch and disconnect the I/O cable from the connector on the I/O board.
- Lift and remove the I/O cable from the palmrest assembly.
Data is not available for the Topic