Installing the heatsink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the heatsink assembly and provides a visual representation of the installation procedure.
![Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly](https://dl.dell.com/content/guides/public/Html/latitude-3430-service-manual/images/GUID-D6D6D3C7-07CB-48A7-9522-4DF118DEA164-low.jpg)
Steps
- Align and place the heatsink assembly into the slot on the system board.
- In sequential order, tighten the four captive screws (4->5->6->7) that secure the heatsink assembly to the system board.
- Adhere the tape that secures the antenna cables to the heatsink assembly.
- Adhere the tape that secures the heatsink assembly to the system board.
Data is not available for the Topic