Installing the battery cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery cable and provides a visual representation of the installation procedure.
![Installing the heat sink](https://dl.dell.com/content/guides/public/Html/latitude-3430-service-manual/images/GUID-8C8B7248-CFBE-4C5F-A163-B4E8F8974E20-low.jpg)
Steps
- Connect the battery cable to the connector on the battery.
- Slide the metal above the connector on the battery to lock.
- Route the battery cable through the routing channel in the battery and adhere the adhesive tapes.
- Connect the battery cable to the connector on the system board.
Data is not available for the Topic