Installing the WWAN I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WWAN I/O board and provides a visual representation of the installation procedure.
NOTE: The following steps are applicable only for 4G LTE enabled systems.
Steps
- Connect the WWAN cable to the connector on the WWAN I/O board and close the latch.
- Gently flip the WWAN I/O board toward right.
- Align and place the WWAN I/O board into its slot on the palmrest assembly.
- Install the two (M2x3) screws to secure the WWAN I/O board to the palmrest assembly.
Data is not available for the Topic