Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 3430 Service Manual

PDF

Installing the I/O cable

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the I/O cable and provides a visual representation of the installation procedure.

Removing the heat sink

Steps

  1. Route the I/O cable through the routing guides and adhere the adhesive tape to secure the I/O cable in place.
  2. Connect the I/O cable to the connector on the system board, adhere the adhesive tape, and close the latch.
  3. Connect the I/O cable to the connector on the I/O board, adhere the adhesive tape, and close the latch.

Next steps

  1. Install the base cover.
  2. Exit the service mode
  3. Install the microSD-card.
  4. Install the SIM card tray for 4G LTE enabled systems.
  5. Follow the procedure in after working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\