Installing the I/O cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the I/O cable and provides a visual representation of the installation procedure.
Steps
- Route the I/O cable through the routing guides and adhere the adhesive tape to secure the I/O cable in place.
- Connect the I/O cable to the connector on the system board, adhere the adhesive tape, and close the latch.
- Connect the I/O cable to the connector on the I/O board, adhere the adhesive tape, and close the latch.
Data is not available for the Topic