If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:The display panel is pre-assembled with the display brackets as a single service part. Do not pull and release the Stretch Release (SR) Tapes from the display panel and separate the brackets from the display panel.
The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
Steps
Align and place the display panel on the display assembly.
Connect the display cable to the connector on the display panel, close the latch and affix the adhesive tape.
Install the six
(M2.5x2.5) and two (M2.5x3) screws to secure the left and right hinge brackets in place.