NOTE:The display panel is pre-assembled with the display brackets as a single service part. Do not pull and release the Stretch Release (SR) Tapes from the display panel and separate the brackets from the display panel.
The following images indicate the location of the display panel and provide a visual representation of the removal procedure.
Steps
Remove the six
(M2.5x2.5) and two (M2.5x3) screws that secure the left and right hinge brackets in place.
Gently flip over the display panel.
Peel the adhesive tape, open the latch and disconnect the display cable from the connector on the display panel.
Lift and remove the display panel from the display assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\