Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation procedure.
![Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly](https://dl.dell.com/content/guides/public/Html/latitude_3420_sm_discrete/images/GUID-69E6025F-0E3B-49D9-8D27-38FB4A6E9BFB-low.jpg)
![Image: Removing the screws that secure the base cover to the palm-rest and keyboard assembly](https://dl.dell.com/content/guides/public/Html/latitude_3420_sm_discrete/images/GUID-DC2C5B4E-6ABF-477A-8286-361C44EF53BC-low.jpg)
Steps
- Align and place the system chassis under the hinges of the display assembly.
- Press the left and right hinges in downward direction toward the palmrest assembly.
- Install the
three (M2.5x6) and two (M2.5x4) screws to secure the display hinges to the palmrest assembly.
- Connect the display cable to the connector on the system board and close the latch.
- Route the display cable through the routing guides in the palmrest assembly.
- Affix the adhesive tape to secures the display cable in place.
Data is not available for the Topic