Installing the 3-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
- Connect the battery cable to the connector on the battery.
- Slide the metal above the connector on the battery to lock.
- Route the battery cable through the routing channel in the battery and adhere the adhesive tapes.
- Align and place the battery in the slot on the palmrest assembly.
- Install the three (M2X3) screws to secure the battery in place.
- Connect the battery cable to the connector on the system board.
Data is not available for the Topic