Removing the display assembly
Steps
- Peel off the tape securing the wireless antenna from the system board [1].
- Disconnect the display cable from the connector on the system board [2, 3].
- Unroute the display cable from the routing guides on the palmrest and keyboard assembly [1].
- Remove the six (M2.5x5) screws that secure the left and right hinges to the system board, and palmrest and keyboard assembly [2].
- Lift the palmrest and keyboard assembly at an angle [1].
Note: Do not open the display assembly beyond 135 degrees to avoid damage to the display hinges.
- Continue to lift the palmrest and keyboard assembly until it separates from the hinges [2].
- Slide and remove the palmrest and keyboard assembly off the display assembly.
- After performing all the preceding steps, you are left with display assembly.
Data is not available for the Topic